SmartConnection
SmartConnect Configuration Guide
This guide explains how to configure SamrtConnect on supported Motorola MXP600, MXP660 and MXM600 radios for use with the TETRAPACK SmartConnect Gateway.
The instructions assume the user has already purchased the DimetraConnect feature license and has compatible firmware installed on the radio.
Requirements
Before configuring DimetraConnect, ensure the following prerequisites are met.
Radio Requirements
The radio must have:
-
DimetraConnect feature licensed
-
Firmware MR2025.2b or newer
-
Working Wi-Fi capability
Software Requirements
Configuration requires:
-
Motorola Tetra CPS Plus 8.4 or newer
Network Requirements
The radio must have access to the internet via Wi-Fi and be able to reach the TETRAPACK gateway.
SmartConnect Gateway
The TETRAPACK SmartConnect gateway endpoint is:
Mobilty and System Parameters
Radio Configuration (CPS)
Open the radio configuration in Tetra CPS Plus 8.4.
Step 1 – Configure Wi-Fi
Create a new Wi-Fi profile and configure:
-
SSID
-
Security mode
-
Password
Write the configuration to the radio.
Step 2 – Configure SmartConnect
Within CPS, configure the SmartConnect connection parameters.
Enter the TETRAPACK gateway:
Write the configuration to the radio.
Troubleshooting
If the radio fails to connect to the gateway, the most common cause is a cached certificate or invalid DimetraConnect profile.
Reset the DimetraConnect certificates using the radio Test Mode.
Enter Test Mode
On the radio keypad enter:
This opens the Test Mode menu.
Delete DimetraConnect Certificates
Delete the stored certificate.
After deleting the certificate:
-
Restart the radio
-
Reconnect to Wi-Fi
-
Attempt the DimetraConnect connection again
Additional Notes
-
Radios must have a valid DimetraConnect feature license installed.
-
Firmware older than MR2025.2b may not support the required connection methods.
-
Ensure outbound TCP connectivity to the gateway port is allowed.